2-(4-吡啶)丙二醛

  • 基本信息
  • 物化性质
  • 安全信息
  • 毒理性
  • MSDS
  • 海关数据
  • 结构与计算化学
  • 上游产品
  • 下游产品

2-(4-吡啶)丙二醛 基本信息

中文名称:
2-(4-吡啶)丙二醛 
中文别名:
2-(4-吡啶)丙二醛;
2-(4-吡啶基)丙二醛 
英文名称:
Propanedial,2-(4-pyridinyl)-
英文别名:
2-(4-Pyridyl)malondialdehyde;
2-(Pyridin-4-yl)malonaldehyde;
2-pyridin-4-ylpropanedial 
CAS No.:
51076-46-1
分 子 式:
C8H7NO2
分 子 量:
149.15
精确分子量:
149.04800
PSA:
47.03000
MDL:
MFCD00216535
InChI:
The Key: RYYVVCNGQOENKM-UHFFFAOYSA-N
风险术语:
R34
安全术语:
S26S45S36/S37/S39
分子结构式:
SDS:
查看

2-(4-吡啶)丙二醛 物化性质

外观与性状:
米色至棕色粉末
密度:
1.171g/cm3
熔点:
320ºC
沸点:
269.3ºC at 760mmHg
闪点:
120.7ºC
折射率:
1.522
存储条件/存储方法:

 

 密闭于阴凉干燥环境中

稳定性相关:

 

遵照规定使用和储存则不会分解。

其它信息:

1.       性状:固体

2.       密度(g/mL,25/4):无可用

3.       相对蒸汽密度(g/mL,空气=1):无可用

4.       熔点(ºC):320

5.       沸点(ºC,常压):无可用

6.       沸点(ºC,5.2kPa):无可用

7.       折射率:无可用

8.       闪点(ºC):无可用

9.       比旋光度(º):无可用

10.    自燃点或引燃温度(ºC):无可用

11.    蒸气压(kPa,25ºC):无可用

12.    饱和蒸气压(kPa,60ºC):无可用

13.    燃烧热(KJ/mol):无可用

14.    临界温度(ºC):无可用

15.    临界压力(KPa):无可用

16.    油水(辛醇/水)分配系数的对数值:无可用

17.    爆炸上限(%,V/V):无可用

18.    爆炸下限(%,V/V):无可用

19.    溶解性:无可用

2-(4-吡啶)丙二醛 安全信息

海关代码:
2933399090
危险类别码:
R34
安全说明:
S26-S45-S36-S37-S39
安全标志:
S26:万一接触眼睛,立即使用大量清水冲洗并送医诊治。
S45:出现意外或者感到不适,立刻到医生那里寻求帮助(最好带去产品容器标签)。
:
危险标志:
C,Xi

2-(4-吡啶)丙二醛 毒理性

生态数据:

 

该物质对环境可能有危害,对水体应给予特别注意。

2-(4-吡啶)丙二醛 MSDS

Name: 2-(4-Pyridyl)malondialdehyde Material Safety Data Sheet
Synonym: None
CAS: 51076-46-1
Section 1 - Chemical Product   MSDS Name:2-(4-Pyridyl)malondialdehyde Material Safety Data Sheet
Synonym:None

Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS
CAS# Chemical Name content EINECS#
51076-46-1 2-(2-pyridyl)malondialdehyde 100 % unlisted
Hazard Symbols: C
Risk Phrases: 34

Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Causes burns.Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract.
Chronic:
No information found.

Section 4 - FIRST AID MEASURES
  Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:

Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry chemical, carbon dioxide, or appropriate foam.

Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal container. Clean up spills immediately, observing precautions in the Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

Section 7 - HANDLING and STORAGE
  Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Minimize dust generation and accumulation. Avoid contact with eyes, skin, and clothing. Keep container tightly closed.
Do not ingest or inhale. Use with adequate ventilation. Discard contaminated shoes.
Storage:
Store in a cool, dry place. Keep container closed when not in use.
Corrosives area.

Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 51076-46-1: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.

Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Solid
Color: white to off-white
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: > 320 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: slightly soluble in water
Specific Gravity/Density:
Molecular Formula: C8H7NO2
Molecular Weight: 149.0545

Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Strong bases, strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and gases, carbon dioxide.
Hazardous Polymerization: Has not been reported

Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 51076-46-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
2-(2-pyridyl)malondialdehyde - Not listed by ACGIH, IARC, or NTP.

Section 12 - ECOLOGICAL INFORMATION
 

Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.

Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: CORROSIVE SOLID, N.O.S.*
Hazard Class: 8
UN Number: 1759
Packing Group: III
IMO
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing Group: III
RID/ADR
Shipping Name: CORROSIVE SOLID, N.O.S.
Hazard Class: 8
UN Number: 1759
Packing group: III

Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 51076-46-1: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 51076-46-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 51076-46-1 is not listed on the TSCA inventory.
It is for research and development use only.


SECTION 16 - ADDITIONAL INFORMATION
N/A

2-(4-吡啶)丙二醛 海关数据

中国海关编码:2933399090

概述:
2933399090. 其他结构含非稠合吡啶环的化合物. 增值税率:17.0%. 退税率:13.0%. 监管条件:无. 最惠国关税:6.5%. 普通关税:20.0%
申报要素:
品名, 成分含量, 用途, 乌洛托品请注明外观, 6-己内酰胺请注明外观, 签约日期
摘要/Summary:
2933399090. other compounds containing an unfused pyridine ring (whether or not hydrogenated) in the structure. VAT:17.0%. Tax rebate rate:13.0%. . MFN tariff:6.5%. General tariff:20.0%

2-(4-吡啶)丙二醛 分子结构与计算化学数据

分子结构数据

1   摩尔折射率:38.90

2   摩尔体积m3/mol127.3

3   等张比容(90.2K):334.2

4   表面张力dyne/cm47.4

5   极化率10-24cm315.42

计算化学数据

1.疏水参数计算参考值(XlogP):0

2.氢键供体数量:0

3.氢键受体数量:3

4.可旋转化学键数量:3

5.互变异构体数量:3

6.拓扑分子极性表面积47

7.重原子数量:11

8.表面电荷:0

9.复杂度:133

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:1

推荐供应商更多供应商>>

常州英飒科技发展有限公司

产品介绍:
产品名称:2-(4-吡啶)丙二醛 Cas号:51076-46-1 纯度:97% 包装信息:1g、10g、50g、100g、500g、1kg、10kg; 价格:洽谈
联系方式:
联系人:张经理 电话:15151934985 手机:15151934985

武汉赢元贝商贸有限公司

产品介绍:
产品名称:2-(4-吡啶)丙二醛 Cas号:51076-46-1 纯度: 包装信息:100kg 价格:洽谈
联系方式:
联系人:刘 电话:0278880000 手机:13349903920

郑州杰克斯化工有限公司

产品介绍:
产品名称:2-(4-吡啶)丙二醛 Cas号:51076-46-1 纯度: 包装信息:洽谈 价格:洽谈
联系方式:
联系人:许伟伟 电话:0371-86259281 15981966935 手机:15981966935

上海慧博化学科技有限公司

产品介绍:
产品名称:2-(4-吡啶)丙二醛 Cas号:51076-46-1 纯度: 包装信息:洽谈 价格:洽谈
联系方式:
联系人:汪杰 电话:021-54828380 手机:18602176165